Acme Fluid Handling Pty Ltd
Machinery in Greater Dandenong

Acme Liquid Handling Pt Ltd is Australia's leading manufacturer and supplier of electronic flow metering systems, and dispensing equipment for both road tanker and static installations. Acme also represents in Australia, some of the latter international suppliers of equipment for the oil and gas industry. The Acme ATM Series Turbine Flow meter, represents a important advance in turbine meter design, offering linear flow characteristics normally associated with definite displacement meters combined with exceptionally long life. Acme Conversion kits donate metering system design flexibility, with partition pulse generator and totaliser. Propane bobtail truck with Acme ATM series metering system and hose reel, fully designed and fitted out by Acme. Arm balancing is by spring cylinder and gas strut, the design illustrated under also includes an Emergency free system in the event of the Tanker attempting to drive away while the arm is connected to it. We can supply both LiquaTech and Neptune components. LiquaTech also yield a competitively priced range of replacement parts for Neptune meters. Note: Neptune is trade mark of Actaris corp. We also donate a packed in house reconditioning service for both pumps and compressors Acme Also supply a range of replacement parts for blacker LPG pumps and compressors. While the swivel design ensures a lengthy service life they are also fully repairable. This Acme fitting spanners are designed to be assembled with vapor and liquid hoses and are retained on the hose behind the star nut. OPERATING INSTRUCTIONS The microelectronic totaliser will calculate and display both a delivery whole and a successive (cumulative) total. DELIVERY Totals Unless otherwise indicated the display will divulge the delivered entire in one tenth liters up to a maximum of 99.9. For totalisers with silver buttons big-hearted a one shot pulse of concise duration (approximately 34 of a second) it is necessary to press on the button at minimum twice at intervals of about half of one second in order to offer the needed consecutive pulse length. For totalisers with yellow buttons the TOTAL is displayed as long as the button is depressed. Program the meter identification no. If a digit does not need to be reset a second propel of the RESET button will move the sequence to the following digit. In the case of the totaliser with silver buttons allow one second between continuous pushes on the RESET button to avoid overlapping pulses. Failing to perform this last operation will depart the preceding complete in the memory and the entire process must be repeated. This mode sets the numbers following the decimal point and operates in the identical way as the preceding sequence. APPENDIX An Adjusting the factor When calibrating the instrument against a known measured volume, the indicated volume on the totaliser is compared with the actual obvious volume delivered into the measure and the percentage variation is premeditated as follows: Indicated volume x 100 Measured volume. The curve can now be approximated by nine frequency ranges with constant factors. Note: Permit four seconds from the time the delivery has ended to the time the RESET button is pressed.